Infinity Reference 3004A

Features:

• 4-Channel Design: The Infinity Reference 3004A is designed to provide 75W RMS x 4 channels @ 4 and 100W RMS x 4 channels @ 2. Both front and rear pairs of channels can be bridged into a 4 load, providing 200W RMS x 2.
• Class H Design: The Infinity Reference 3004A is equipped with high-performance Class H amplifier topology. Class H is designed to provide sound quality approaching Class AB, while providing Class D type efficiency and low-power consumption.
• Low Noise & Distortion: The 3004A amplifier features balanced differential inputs to ensure low noise and distortion, even at high output levels. This also makes it less susceptible to line induced, radiated engine noise.
• Protection Circuitry: The amp features 3-way protection, and will shut itself down
• Power and Protection LEDs: The amplifier features a Power and Protection LED on the input side of the unit. The Power LED illuminates Green when the amplifier is supplied power. The Protection LED will illuminate Red when the amplifier goes into protect-mode.
• Compact Size: The Reference 3004A is housed in a compact chassis with a small footprint, allowing it to fit in more vehicles where mounting space is limited.
• Hidden Control Panel: The top panel of the Reference 3004A can unsnap and slide off to access all of the amp’s controls.
• Gain: Both front and rear pairs of channels have their own rotary control to match the level of the input signal
• Filter & Frequency: Both front and rear channels can have a crossover applied to them. A 3-way switch for each lets you select: HPF (high-pass), LPF (low-pass), or FULL (full-range). This variable 12dB per octave filter includes a Freq dial that can be set between 32Hz and 320Hz.
• Turn-On Mode: Lets you select whether you are using high- or low-level input signals.
• Input Level: Working in conjunction with the Turn-On Mode, this 3-way switch lets you set the input sensitivity range
• Preamp & Speaker Input: Two pairs of RCA jacks are used for both low-level and high-level signals. If using high-level, 4 speaker wire-to-RCA adapters are provided. These feature an RCA plug on one end and 2 wire-ports with set-screws on the other end, accepting speaker wire up to 18 ga.
• Preamp Outputs: A pair of RCA output jacks are provided to pass the incoming signals out to additional amplifiers, without the need for RCA splitters.
• Speaker Output: Eight set-screw terminals for connecting speaker wires; accommodating up to 8 ga. (16 ga. minimum recommended).

Specifications:

• 4 channel car amplifier
• 75 watts RMS x 4 at 4 ohms
• 100 watts RMS x 4 at 2 ohms
• 200 watts RMS x 2 at 4 ohms in bridged mode
• (4-ohm stable in bridged mode)
• Variable high- and low-pass filters (32320Hz,
• 12dB/octave) on front and rear channels
• Preamp and speaker-level inputs
• Preamp outputs
• Fuse rating: 30A x 2
• 8-gauge power and ground leads recommended
• wiring and hardware not included with amplifier
• W x H x D = 320mm x 55.5mm x 180mm
• W x H x D = 12-5/8″ x 2-3/16″ x 7-1/8″

• UPC: 050667375492
• Weight: 10
• Authorized Internet Dealer